ME-Link SMS Alarm/Status Communicator

MATelec Australia’s SMS Alarm/Status Communicator features our newly designed ME-Link module, which is a cellular CAT-M1 remote monitoring and control device utilising the 700Mhz frequency for ‘best in class’ signal strength. The ME-Link reports status information and active alarms from up to 8 digital inputs, which can be connected to volt free outputs on a control panel or used for sensor inputs. The ME-Link Module can also be utilised to control external devices with the two onboard relay outputs, and uses easy to set up SMS commands to configure the operation and alarms without the need for any additional software. The Communicator is available in a flexible version suitable for any application, as well a version designed to communicate status/alarms from our Standard Single and Dual Pump Controllers via their BMS/remote output.

  • SMS messaging from up to 8 digital inputs, including power/battery supply status
  • Easy programming with SMS commands
  • Up to 10 phone numbers can receive messages
  • Smart help responses on incorrect commands
  • Once, repeat or sequential notification messaging
  • Repeat or sequential messaging until user accepted
  • Daily reminder messages for active alarms
  • Remote control of systems and or devices via the 2 relay outputs
  • Periodic test messages to ensure ME-Link is connected and operating
  • Temporary disabling of notifications for site servicing
  • Logged data for ‘last alarm’, ‘acknowledgment time and number’.
Enclosure
  • IP54 rated, powder coated mild steel enclosure with removable gland plate
Protection
  • Low voltage control and input circuitry
  • Din rail mounted terminal connections
Control & interface
  • ME-Link IoT/SMS module (requires micro SIM card from network provider with CAT-M1 enabled)
  • Vandal resistant antenna (remote mount high gain antenna also available for low signal strength areas)
  • BMS interface board for interface between ME-Link and Single/Dual Pump Controller (FPC-30120)
  • Battery backup for mains power failure
Inputs
  • Single phase (230Vac) power supply
  • 6x Digital inputs for connection to volt free outputs on any control panel or for sensor inputs (only 2x on FPC-30120)
  • Input for connection to BMS/remote output from a MATelec Standard Single or Dual Pump Controller (FPC-30120)
Outputs
  • 2x Relay outputs (on ME-Link module)
Included with panel
  • 10 Amp 3 pin 1.5m power supply lead

SMS Alarm/Status Communicator

Code Description Enclosure Size
FPC-30121 SMS Alarm/Status Communicator 300x300x150mm

 

Customer Support

Want to know more about our comprehensive and innovative electrical products and bespoke engineered solutions?

Contact Us