MORE THAN COMPONENTS.
COMPLETE CUSTOM SYSTEMS.
The MATelec Australia Advantage
Where MultiSmart was a stand-alone control module and the MultiTrode
a probe, MATelec Australia delivers entire systems. From concept to
completion, we design and build control panels that include everything,
from compliant power supply termination and isolation, to labelled motor
connection terminals, – customised to your application requirements.
One supplier, one complete solution, ready to go.
MORE SET POINTS.
MORE FLEXIBILITY.
Hydrostatic Transducer
Configurability vs MultiTrode
The MultiTrode’s rigid design limits control to a fixed number
of level points in a fixed probe length, based on sensor spacing.
However, with a hydrostatic transducer, the variables are infinite.
Set your switching setpoints at any desired level within the pit.
It’s the flexibility your application demands.
UNMATCHED PRECISION WITH
REDUCED MAINTENANCE.
Hydrostatic Transducer
Accuracy vs MultiTrode
The hydrostatic transducer measures level from near the
base of the pit, making it a far more accurate and reliable
level sensor, than conductivity-based sensors.
MultiTrode probes, hanging through the liquid surface,
are prone to scum build-up and crusting around each sensing
point, rendering their switching signals unreliable,
without regular maintenance. We hear all too often of
situations where debris such as toilet paper and other
suspended solids wraps itself around a sensing point,
causing a pump to run constantly, when there may not be water
to pump, thereby overheating, burning out the pump motor,
and in some cases, disfiguring discharge pipework.
In the case of the Hydrostatic Transducer, it is
suspended immediately above the floor of the pump well, an
area considerably lower than the operational water level
within the well, minimising maintenance and servicing demands.
